Carbide Tip Centers


  • Carbide Tipped Dead centers
  • Carbide Tipped Plain centres
  • Centres for Grinding Machines

Selection & Ordering

The selection depends on the spindle nose of a machine and carbide tip bearing area required for a job

To order the right size of CT centers, specify the angle of cone and shank size required

Description & Features

The Carbide Tipped Centres are made of alloy steel shank fitted with tungsten-carbide tips by brazing. The shanks are made of low carbon steel hardened to 40 HRC. The cones where the carbide tips are mounted are given a fine surface finish.

Common Uses

The CT centers are mainly used on grinding machines. On high rpm lathes use of these Ct centres are recommended

Scope of Supply

The CT centres have carbide tips, fitted on the front cones, as per IS Specifications. Special tips can also be supplied according to specific customer requirements, eg: half carbide tips.

The Carbide tip dead centers are available with Morse Taper shanks, in sizes from MT-1 to MT-6, and cone angle of 60 degree. Other cone angles of 30 or 45 degrees can also be supplied

Ordering Example

Smitra CT Centres - MT-3 / 60 degree

Similar Products